Prevent rust and other stains in your toilet with these tips
Let’s admit it, everyone hates cleaning the bathroom. It’s certainly not the most coveted job out there. But when the toilet gets stained or rusted, and no matter how much you scrub it, there’s no difference, then toilet cleaning goes to a whole new level of horrible. One of the most common causes of a dirty toilet is rust. It not only makes your bowl look disgusting, but it also makes your bathroom-cleaning efforts completely futile.
There is also another set of stains that can form in your toilet due to hard water mineral deposits, which in turn form bacteria and plenty of different-colored hues. No matter what has caused the stain in your toilet, it’s not at all a pleasant sight to see. Thankfully, there are several ways to remove these stains from your toilet and leave your toilet bowl as good as new. We mention them in this article.
The origin of rust and other stains is multifold.
-Iron in water is one of the major reasons, not only in the toilet bowl but also in the tub and sink.
-When air merges with these particles, they tend to oxidize and cause coloration.
-When these are continuously run over surfaces, it leaves behind hard mineral deposits, causing the stain.
-Taking the right methods into account, you can reduce iron by manifold, and keep your basins or tubs without stains.
Ways to remove stains when they have already occurred:
So you haven’t taken measures before reading this article and stains have already taken over? Don’t worry! There are many methods to remove stains completely. However, you should avoid using typical and chemically-induced methods such as bleach, because the compounds in bleach can make the rust stains every worse.
Ensure that your cleaning techniques are safe to use as certain methods can cause scratches on your toilet bowls or tubs, and might even promote more debris buildup.
Here are some solutions to remove stains:
-Create a solution of vinegar and water in equal halves and spray it on the stains. Let it sit for a while and then scrub the stain off with a toiler brush.
-Another solution includes a three-fourths part baking soda and a one-fourth part of vinegar. Do the same process as before by putting the powder on the stain and letting it sit. After some time, scrub the stain off with a brush.
-Use one-fourth cup of Borax and dust it into the toilet bowl. Scrub with a brush to remove stains. This also helps with any bacteria or odor buildup.
Tips to prevent rust and other stains in your toilet or sink
Clean your toilet bowl regularly, at least once a week, to ensure that there isn’t any buildup of debris. A toiler bowl cleaner and a brush should suffice. First, tackle the outer surfaces with a disinfectant wipe. In case you’re sharing the toilet with your whole family make sure to clean it up every 2-3 days. After cleaning, flush the toilet.
Another good tip is using vinegar to prevent water rings or limescale deposits from appearing in your toilet bowl. With just 3 cups of vinegar, after ensuring that all sides are covered, keep it on for some time. Then scrub the bowl with a brush and flush.
Clean your bathroom often
When you clean your bathroom at least once a week, the buildup of iron and other mineral deposits becomes lower. It’s important to do this at least once a week and to keep it as dry as possible. Whenever there is excess residue, wipe those areas thoroughly.
Check for metals
If there are metal cans including shaving cream, fresheners, or metal bottles, they could lead to rust stains on your shower or bathtub surface. Ensure that you keep them inside a cupboard.
Filters
To keep mineral deposits as low as possible in your bathroom ,place an iron filter or a water softener that takes the problem away at the source.
Take your plumbing up a notch
If you’re staying in an older house that has iron pipes, you might face rust deposits and this will eventually lead to a breakdown. Improve your old pipes and take them to the next level with experts like Octopus.
Flush toilets that aren’t used often regularly
When you flush regularly, you improve the incidence of pink bacteria stains in your toilet. These stains are very hard to remove once formed. In case there is a toilet at home that doesn’t get used much, switch the water off completely and keep it clean.
Use a toilet bowl cleaner the right way
Many people don’t use a toiler bowl cleaner to the best of its capabilities. For the best results, spray the cleaner within and around the bowl and keep it on until the next time you have to use the toilet. Once it has sat for a while, use a toilet brush cleaner to remove any residue and flush.
Tank tablets
Tank tablets are of several varieties and you have to make sure that you use the non-corrosive type. Make sure that they don’t include bleach or other forms of chemicals that can cause damage to the valves. Pick natural tablets.
Polymer-based car wax
To protect your toilet from stains, consider coating it in polymer-based car wax. First, take out any existing stains and then dry the bowl fully with a rag. Then with another cotton cloth, rub the car wax within your toilet bowl. Keep the wax on for at least 10 minutes before placing water in it once again.
Use Teflon
Certain cleaners which have Teflon are useful to protect your toilet bowls from all types of stains. Put the cleaner within the inside of your toilet bowl and then clean it. Use this regularly for the best results.
Prevent rust and other stains in your toilet with ease
We hope this guide on preventing rust and other stains in your toilet was useful! Remember, if your plumbing and pipes are healthy, your toilet will be cleaner. Make sure to get regular plumbing checks at home with experts such as Octopus. It’s imperative to make this a part of your annual maintenance contract.
For more information, get in touch with us on 800 3993.
